Completing The Parts Replacement - Lenovo 10GS User Manual

5. Pivot the drive bay assembly upward. See "Pivoting the drive bay assembly upward and downward"
on page 59.
6. Remove the heat sink fan duct. See "Replacing the heat sink and fan assembly" on page 70.
7. Locate the power supply assembly. See "Computer components" on page 6 .
8. Disconnect the power supply assembly cables from the system board.
9. Remove the three screws that secure the power supply assembly. Pressing the retaining clip
downward, slide the power supply assembly to the front of the computer and lift it out of the chassis.
Figure 42. Removing the power supply assembly
10. Position the new power supply assembly in the chassis so that the three screw holes in the power
supply assembly align with those in the chassis. Then, install the three screws to secure the power
supply assembly.
11. Connect the power supply assembly cables to the system board. See "Parts on the system board"
on page 8 .
12. Reinstall the heat sink fan duct. See "Replacing the heat sink and fan assembly" on page 70.
13. Pivot the drive bay assembly downward. See "Pivoting the drive bay assembly upward and downward"
on page 59.
14. Reinstall the optical drive. See "Replacing the optical drive" on page 57.
15. Reinstall the front bezel. See "Replacing the front bezel" on page 54.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.

Completing the parts replacement

After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 35.
To reinstall the computer cover and reconnect cables to your computer, do the following:
76
ThinkCentre M700 User Guide
1