Table of Contents
Advertisement
To replace the VESA mount bracket, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the slide cover. See "Removing the slide cover" on page 85.
3. Remove the bottom cover. See "Replacing the bottom cover" on page 86.
4. Remove the Orchid Tilt Stand. See "Replacing the Orchid Tilt Stand" on page 92.
5. Remove the system board shield. See "Replacing the system board shield" on page 97.
6. Remove the cover presence switch. See "Replacing the cover presence switch" on page 98.
7. Release the I/O board cable from the cable guides as shown. Then, remove the two screws that secure
the VESA mount bracket to remove it from the computer.
Figure 36. Removing the VESA mount bracket
8. Align the two screw holes in the new VESA mount bracket with the corresponding screw holes in the
computer. Then, install the two screws to secure the bracket.
Figure 37. Installing the VESA mount bracket
9. Route the I/O board cable through the cable guides in the new VESA mount bracket.
10. Reinstall the cover presence switch. See "Replacing the cover presence switch" on page 98.
11. Reinstall the system board shield. See "Replacing the system board shield" on page 97.
12. Reinstall the Orchid Tilt Stand. See "Replacing the Orchid Tilt Stand" on page 92.
13. Reinstall the bottom cover. See "Replacing the bottom cover" on page 86.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
100
ThinkCentre X1 Hardware Maintenance Manual
Advertisement
Table of Contents
