Removing/Reattaching The Cover Using Procedure B - YASKAWA T103 Installation & Primary Operation

6 Mechanical Installation
3.
Reattach the keypad to the original position.
■

Removing/Reattaching the Cover Using Procedure B

DANGER Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before servicing,
disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal capacitor
stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage decreases below 50
Vdc. When all indicators are OFF, remove the covers before measuring for dangerous voltages to make sure that the drive is safe. If
you do work on the drive when it is energized, it will cause serious injury or death from electrical shock.
Remove the Front Cover
1.
Remove the terminal cover, keypad, and keypad connector, then insert the end of the keypad connector that
has the tab into the keypad connector holder on the front cover.
A - Keypad
B - Keypad connector
Figure 6.7 Remove the Terminal Cover, Keypad, and Keypad Connector
2.
Loosen the front cover screws.
18
Figure 6.6 Install the Front Cover
C - Connector holder
Figure 6.8 Loosen the Front Cover Screws
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation