Table of Contents
Advertisement
10 Drive Start-Up
Motor Base Rotation Speed
Number of Motor Encoder Pulses
The drive setup wizard prepares the drive for operation. Use the information from the table to do Auto-Tuning and
test runs.
1.
Energize the drive to show the initial setup screen.
Note:
If the keypad does not show the Initial Setup screen, push
[Initial Setup].
2.
Select [Set Date/Time] to set the date and time.
Note:
Open the clock battery cover and put in a battery to use the clock functions. Use a Hitachi Maxell CR2016 manganese dioxide
lithium battery or an equivalent battery with these properties:
• Nominal voltage: 3 V
• Operating temperature range: -20°C to +85°C (-4°F to +185°F)
• Nominal battery life: 2 years (20°C (68°F) ambient temperature)
3.
Select [Setup Wizard] and follow the instructions shown on the keypad.
When you finish Setup Wizard, the drive and motor are ready for operation.
Note:
Refer to
Disable the Initial Setup Screen on page 40
◆
Change Parameter Setting Values
This example shows how to change the setting value for C1-01 [Acceleration Time 1]. Do the steps in this procedure
to set parameters for the application.
1.
Push
(Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown above the
2.
Push
(Menu).
38
Item
if you do not want to show the initial setup screen when you energize the drive.
, push
(Back).
(Menu) to show the Menu screen then push
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation
Value
min
-1
to select
(r/min)
ppr
Advertisement
Table of Contents
