Epson S1D10605 Series Manual page 49

When the built-in power is not being used immediately after turning on the power:
2
* The target time of 5ms will result to vary depending on the panel characteristics and the capacitance of the smoothing
capacitor. Therefore, we suggest you to conduct an operation check using the actual equipment.
Notes: Refer to respective sections or paragraphs listed below.
*1: 7. Function description; "Resetting circuit"
*2: 8. Command description; (11) "LCD bias setting"
*3: 8. Command description; (8) "ADC selection"
*4: 8. Command description; (15) "Common output state selection"
*5: 7. Function description; "Power circuit" & 8. Command description; "Setting the built-in resistance
radio for regulation of the V
*6: 7. Function description; "Power circuit" & 8. Command description; "Electronic volume control"
*7: 7. Function description; "Power circuit" & 8. Command description; "Power control setting"
*8: The power saver ON state can either be in sleep state or stand-by state.
8. Command description; Power saver START (multiple commands)
Rev.2.1
Turn ON the V -V power keeping the
DD SS
RES pin = LOW.
When the power is stabilized
Release the reset state. (RES pin = HIGH)
Initialized state (Default) *1
Power saver START (multiple commands) *8
Function setup by command input (User setup)
(11) LCD bias setting *2
(8) ADC selection *3
(15) Common output state selection *4
Function setup by command input (User setup)
(17) Setting the built-in resistance radio
for regulation of the V
(18) Electronic volume control *6
Power saver OFF *8
Function setup by command input (User setup)
(16) Power control setting *7
This concludes the initialization
voltage"
5
voltage *5
5
EPSON
S1D10605 Series
Arrange to be in the power saving
state within 5ms after releasing the
reset state.
Arrange to start power control
setting within 5ms after turning
OFF the power saver.
47