Epson S1D10605 Series Manual page 42

S1D10605 Series
• The sequence for cursor display
(13) End
This command releases the read/modify/write mode, and returns the column address to the address it was at when the
mode was entered.
E R/W
A0 RD WR D7 D6 D5 D4 D3 D2 D1 D0
0 1 0 1 1
Column address
(14) Reset
This command initializes the display start line, the column address, the page address, the common output mode, the V
voltage regulator internal resistor ratio, the electronic volume, and the static indicator are reset, and the read/modify/
write mode and test mode are released. There is no impact on the display data RAM. See the 7. Function Description
in "Reset" for details.
The reset operation is performed after the reset command is entered.
E R/W
A0 RD WR D7 D6 D5 D4 D3 D2 D1 D0
0 1 0 1 1
The initialization when the power supply is applied must be done through applying a reset signal to the RES terminal.
The reset command must not be used instead.
40
Page address set
Column address set
Read/modify/write
Dummy read
Data read
Data write
No
Change complete?
End
1 0 1 1 1 0
N N+1
Read/modify/write mode set
1 0 0 0 1 0
Data process
Yes
Figure 18
N+2 N+3 • • •
Figure 19
EPSON
Return
N+m N
End
5
Rev.2.1