Assembly - Craftsman 137.054450 Operator's Manual

WARNING
!
For your safety, never connect plug
to power source receptacle until all
assembly and adjustment steps are
complete, and you have read and
understood the safety instructions.
ASSEMBLING THE STAND LEGS TO
STAND (FIG. A, B)
1. Insert one front stand leg (1) into
one side of the stand assembly
using two bolts (2), four washers (3)
and two nuts (4).
2. Insert the other front stand leg (5)
into the other side of the stand
assembly in the same manner.
NOTE: The bent parts of the stand
legs (1, 5) should point outward in
opposite directions from each other.
3. Tighten using an adjustable wrench
for the nuts (4) and a Phillips
screwdriver for the bolts (2).
NOTE: This adjustable foot pad is
used to level the saw. Loosen the
wing nut (6), turn the adjustable
foot pad (7) clockwise to raise and
counterclockwise to lower the stand,
then tighten the wing nut (6). (Fig. B)
Fig. A
5

ASSEMBLY

1
4
3
3
Fig. B
Raise the stand
ASSEMBLING THE ROLLER
WHEELS TO STAND (FIG. C)
1. Attach one wheel (1) to the outer
side of the stand wheel leg using
the hex bolt (2), the sleeve (3), the
flat washer (4) and the nut (5).
NOTE: Verify that the side of the
wheel that has the most ribs (6) is
facing toward the stand as shown.
2. Tighten using two adjustable
wrenches for the nut and bolt.
NOTE: Do not overtighten. Doing
so will not allow the wheels to turn
properly.
3. Repeat the above steps for the
other wheel.
Fig. C
2
20
6
7
Lower the stand
1
4
5
3
2
6