Table of Contents
Advertisement
Fig. AA
2
ADJUSTING MITER GAUGE (FIG. BB)
1. Loosen the lock handle (1) to allow
the miter body (2) to rotate freely.
Position the miter body (2) at 90°
so the positive detent secures its
position. Tighten the lock handle to
hold the miter body in position.
2. If the pointer (3) requires
adjustment, loosen the screw (4)
with a screwdriver. Adjust the
pointer to 90° on the scale, then
firmly tighten the adjustment screw.
3. To change angles on the miter
gauge, loosen the lock handle (1)
and rotate the miter body (2) to
the desired angle as indicated by
the scale. Secure in position by
tightening the lock handle (1).
Fig. BB
3
1
3
2
1
4
ADJUSTING THE TABLE INSERT
(FIG. CC)
WARNING
!
To avoid serious injury, the table
insert (1) must be level with the
table. If the table insert is not flush
with the table, adjust the two bolts (2)
with a 4 mm hex wrench until it is
parallel with the table.
NOTE: To raise the insert, turn the hex
screws counterclockwise, to lower the
insert, turn the hex screws clockwise.
Do not remove the insert, adjustments
need to be made with the insert in
place to get the proper level.
Fig. CC
2
ADJUSTING THE 90° AND 45°
POSTIVE STOPS (FIG. DD, EE)
Your saw has positive stops that will
quickly position the saw blade at 90°
and 45° to the table. Make adjustments
only if necessary.
90° Stop
1 Disconnect the saw from the power
source.
2. Raise the blade to the maximum
elevation.
30
1
1
Advertisement
Table of Contents
