Table of Contents
Advertisement
ASSEMBLING THE STAND
HANDLES TO STAND (FIG. D)
1. Place stand upside down on level
surface or floor.
2. Insert one stand handle (1) into one
stand tube and align the holes on
the handle and tube.
NOTE: The bent parts of the stand
handles (1, 2) should point outward
in opposite directions from each
other.
3. Insert one short screw (3), one long
screw (4), two washers (5) and one
nut (6).
4. Tighten using the Phillips screwdriver
for the screws (3, 4) and the
adjustable wrench for the nut (6).
5. Repeat the above steps for the
other stand handle (2).
Fig. D
5
4
SETTING UP THE STAND (FIG . E, F)
1. Lift up the stand to its vertical
position as shown first in Fig. E.
2. To unfold stand, step on the foot
pedal (1) to release the treadle
hook (2). Press down on the stand
handles to roll the wheel legs
backward and lower the stand to
lock into its work position, as shown
last in Fig. E.
NOTE: You should hear a click
when locked in place.
2
1
6
3
Fig. E
Fig. F
WARNING
!
For your safety, never connect plug
to power source receptacle until all
assembly and adjustment steps are
complete, and you have read and
understood the safety instructions.
ASSEMBLING TABLE SAW TO
STAND (FIG. G)
1. Lift the saw body (1) and place
on the stand (2), aligning the four
mounting holds (3) on the saw base
with the four threaded mounting
holes on the top plate of stand.
21
2
1
Advertisement
Table of Contents
