Table of Contents
Advertisement
2. Raise the blade to the maximum
height position by turning the blade
elevation/tilting handwheel (1)
clockwise. (Fig. Q)
3. Loosen the blade lock handle (2).
Turn and move the handwheel (1)
to 45° on the bevel scale.
4. Tighten the blade lock handle (2).
Fig. Q
5. Place the riving knife (3) on the
mounting bracket (4) located behind
the saw blade. The two pins (5) on
the bracket should fit into the slot on
the riving knife. (Fig. R)
6. Make sure the riving knife (3) is in
its highest position.
7. Insert the set plate (6), making sure
the two outer holes fit into the two
pins on the mounting bracket.
8. Insert the washer (7) into the lock
lever (8) and insert into the middle
hole of the set plate (6) and tighten.
9. Loosen the blade lock knob (2) and
return the blade to 0° and lock.
10. Place the table insert back into
position.
WARNING
!
● To avoid the lock lever interfering
with the table insert, after tighten
the riving knife, position the lock
lever pointing downward before
using saw. Failure to maintain a
level insert can result in serious
injury to the operator.
1
2
25
● The lever can be pulled out to
allow it to be turned to a new
position downward. (Fig. S)
Fig. R
4
5
Fig. S
8
BLADE GUARD AND ANTI-KICKBACK
PAWLS ASSEMBLY (FIG. T, U, V, W)
WARNING
!
● To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug
is disconnected from the power
source outlet.
● When installing the blade guard,
cover the blade teeth with a piece
of folded cardboard to protect
yourself from possible injury.
● Never operate this machine
without the blade guard in place
for all through sawing operations.
3
cavity side face to
lock lever
6 7
8
3
6
Advertisement
Table of Contents
