Table of Contents
Advertisement
MITERING (FIG. aa)
0°~45° miter angle
This sawing operation is the same as
crosscutting except the miter gauge is
locked at an angle other than 90°.
1. Set the blade (1) to 0° bevel angle.
2. Set the miter gauge (2) at the
desired miter angle and lock in
position by tightening the miter
gauge lock handle.
3. Hold the workpiece (3) firmly
against the face of the miter gauge
throughout the cutting operation.
Fig. aa
1
2
3
USING THE WOOD FACING ON THE
RIP FENCE (FIG. bb)
When performing some special cutting
operations, you can add a wood facing
to either side of the rip fence (1).
1. Use a smooth straight 3/4 in. thick
wood board (2) that is as long as
the rip fence.
2. Attach the wood facing to the
fence with wood screws (3) (not
included) through the holes in the
fence. A wood fence should be used
when ripping material such as thin
paneling to prevent the material
from catching between the bottom
of the fence and the table.
Fig. bb
2
NON-THROUGH CUT (FIG. cc)
A non-through cut is used to cut
grooves and rabbets in the workpiece
without exposed the blade.
WARNING
!
● Only this type cut is made
without installing the blade guard
assembly and anti-kickback
pawls assembly.
● To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug
is disconnected from the power
source outlet.
● To avoid the risk of personal
injury. Always use push block,
auxiliary fence and featherboard
when making non-through cut.
1. Before starting the table saw, lower
the blade and riving knife assembly
to the down position.
2. Remove the blade guard assembly
and anti-kickback pawls assembly
for non-through cut.
3. Use the featherboard (1) with
C-clamps (3) to fasten the
workpiece securely.
44
3
1
Advertisement
Table of Contents
