Craftsman 137.054450 Operator's Manual page 22

2. Attach the table saw to the stand
with four hex head bolts (4) and
washers (5).
3. Tighten all mounting bolts with an
adjustable wrench.
NOTE: Do not overtighten the four
bolts as this may cause damage to
the base of the saw.
Fig. G
1
2
NOTE: Before using the saw, verify
that the table saw is securely locked
in position.
FOLDING THE STAND FOR
TRANSPORT OR STORAGE (FIG. H)
NOTE: Before folding the stand, make
sure the side extension table is not
extended and is locked in place.
1. Step on the foot pedal (1), and
slowly lift up on the stand handles (2)
to roll the wheel legs forward and
lower the saw body to lock onto the
front of the stand. You should hear
a click from the treadle hook locking
into place.
2. Place one foot on the wheel legs
crossbar for leverage to initially tilt
stand back onto its wheels into the
transport position. Move saw to
desired location for operation.
3. Store the saw in a dry environment
by lowering the stand from the
transport position all the way down
to rest on the stand handles.
RIP FENCE AND MITER GAUGE
STORAGE (FIG. I)
4
Storage for the rip fence (1) and miter
5
gauge (2) are located on the left side of
the saw housing.
3
PUSH STICK AND BLADE
WRENCHES STORAGE (FIG. J)
1. Attach the metal push-stick storage
2. Insert the blade wrenches into the
22
Fig. H
2
Fig. I
1
2
bracket (1) into the provided slots
on the right side of the body shell (3).
The bracket will snap into place.
slot (2) located to the right side of
the body shell (3).
Fig. J
1
Transporting
1
Storage
3
2