Table of Contents
Advertisement
INSTALLING THE POWER CORD
STORAGE CLAMPS (FIG. K)
1. Attach the power cord storage
clamp (1) into the hole set on the
rear side of the table saw base with
screw (2) and nut (3).
NOTE: The nut is placed inside
the base.
2. Repeat for the other clamp, to be
located on the bottom right on
saw base.
Fig. K
2
POWER CORD STORAGE (FIG. L)
Wrap the power cord (1) as shown. Do
not wrap the power cord around the
dust port (2).
Fig. L
2
INSTALLING THE HANDWHEEL
HANDLE (FIG. M)
NOTE: UP-DOWN is printed on this
handwheel.
1
3
1
1. Thread the handwheel handle (1)
into the handwheel hole (2), and
then tighten with the adjustable
wrench.
Fig. M
INSTALLING THE BLADE
(FIG. N, O, P)
WARNING
!
To avoid injury from an accidental
start, make sure the switch is in the
OFF position and the plug is not
connected to the power source outlet.
1. Remove the table insert (1) by
inserting your finger into the
opening (2) and pulling up.
Raise the blade to the maximum
height position by turning the
blade elevation/tilting handwheel
clockwise. (Fig. N)
Fig. N
23
2
1
1
2
Advertisement
Table of Contents
