National Instruments Compact FieldPoint cFP-1808 Quick Start Manual page 8

2. Install I/O Modules on the Backplane
1. Align the captive screws on the
I/O module with the holes on the
backplane.
2. Press firmly to seat the I/O
module on the backplane.
3. Using a number 2 Phillips
screwdriver with a shank of at
least 64 mm (2.5 in.) length,
tighten the captive screws to
1.1 N · m (10 lb · in.) of torque.
4. Repeat this procedure to install
additional I/O modules on the
backplane.
3. Install Connector Blocks on the Backplane
In order to connect I/O modules to input signals or to external loads, you need to
install a cFP-CB-x connector block or other connectivity accessory for each I/O
module on the backplane. Use the connector socket to the right of each I/O module
socket.
Caution
accessories while power is applied to them.
© National Instruments Corporation
Do not insert or remove connector blocks or other connectivity
7 cFP-1808 Quick Start Guide