1
HANDLEBAR
INSTALLING THE HANDLEBAR
1. Stand the vehicle on a level surface.
w
Securely support the vehicle so that there
is no danger of it falling over.
2. Install:
9 Handlebar
3. Tighten:
9 Handlebar
4. Install:
9 Grip
MMMMMMMMMMMMMMMMMMMMMMM
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end
of the handlebar.
c. Wipe off any excess rubber adhesive with
a clean rag.
w
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
LLLLLLLLLLLLLLLLLLLLLLL
5. Install:
9 Throttle cable
9 Throttle grip 1
NOTE:
Lubricate the inside of the throttle grip with a
thin coat of lithium-soap-based grease and
install it onto the handlebar.
4-18
CHAS
19 Nm (1.9 m·kg, 13 ft·lb)