Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha PW50W 2007 Service Manual

GEN
IMPORTANT INFORMATION
INFO
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/plates
1 and cotter pins. After the bolt or nut has
been tightened to specification, bend the lock
tabs along a flat of the bolt or nut.
1
300-000

BEARINGS AND OIL SEALS

1
Install bearings and oil seals so that the man-
ufacturer's marks or numbers are visible.
When installing oil seals, lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing,
if appropriate.
1 Oil seal
300-003
cC
Do not spin the bearing with compressed
air because this will damage the bearing
surfaces.
1
1 Bearing
300-002

CIRCLIPS

1
Before reassembly, check all circlips carefully
3
and replace damaged or distorted circlips.
2
Always replace piston pin clips after one use.
When installing a circlip 1, make sure the
sharp-edged corner 2 is positioned opposite
4
the thrust 3 that the circlip receives.
4 Shaft
300-001
1-3