Rail Kit; Removing The Right Rail-Kit; Installing The Right Rail-Kit - Dell Precision 7960 Tower Service Manual

NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.

Rail kit

Removing the right rail-kit

Prerequisites
1. Follow the procedure in
2. Remove the left-side
About this task
The following images indicate the location of the right rail-kit and provide a visual representation of the removal procedure.
Steps
1. Remove the four screws (M6x32) that secure the right rail-kit to the chassis.
2. Slide and remove the rail-kit from the slots on the chassis.
3. Replace the four screws (M6x32) to the rail-kit.

Installing the right rail-kit

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right rail-kit and provide a visual representation of the installation procedure.
Steps
1. Remove the four screws (M6x32) from the rail-kit.
2. Align the right rail-kit with the slots on the chassis and slide to secure it in place.
3. Replace the four screws (M6x32) to secure the right rail-kit to the chassis
Next steps
1. Install the left-side cover.
2. Follow the procedure in
116 Removing and installing components
Before working inside your
cover.
After working inside your
computer.
computer.