Rail Kit; Removing The Right Rail-Kit - Dell Precision 5860 Tower Service Manual

8. Install the hard-drive fan
9. Install the M.2 2230 SSD/M.2 2280
10. Install the memory module.
11. Install the 3.5-inch hard drive/2.5-inch hard
12. Install the PCIe holder.
13. Install the air shroud.
14. Install the front I/O bracket.
15. Install the front bezel.
16. Install the side cover.
17. Follow the procedure in
NOTE: Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.

Rail kit

Removing the right rail-kit

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following images indicate the location of the right rail-kit and provide a visual representation of the removal procedure.
104 Removing and installing components
assembly.
SSD.
drive.
After working inside your
Before working inside your
computer.
computer.