Table of Contents
Advertisement
Steps
1. Slide the rear I/O-ports on the system board into the rear I/O-slots on the chassis and align the screw holes on the system
board with the screw holes on the chassis.
2. Replace the 13 (6-32) screws that secure the system board to the chassis.
3. Align and place the bottom-air shroud on the system board.
4. Replace the five (M3) screws to secure the bottom-air shroud to the system board.
5. Connect all the data cables to the connectors on the bottom side of the system board.
6. Connect all the cables to the connectors on the front side of the system board.
Next steps
1. Install the
right-side
cover.
2. Install the processor.
3. Install the
front-fan assembly
4. Install the
heat-sink
assembly.
5. Install the
PCIe
holder.
6. Install the
powered
GPU.
NOTE:
Install the graphics-card rubber protector to the chassis after replacing the system board.
7. Install the
memory
module.
8. Install the
air
shroud.
9. Install the
front
bezel.
10. Install the
left-side
cover.
11. Follow the procedure in
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
and
rear-fan
assembly.
After working inside your
computer.
Removing and installing components
115
Advertisement
Table of Contents
