Table of Contents
Advertisement
2. Place the fan inside the fan bracket.
3. Route the fan cable through the routing clip on the fan bracket.
4. Align and place the fan cover into slots on the fan bracket.
Next steps
1. Install the
rear system-fan
2. Install the
left-side
cover.
3. Follow the procedure in
Installing the rear system-fan assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the rear system-fan assembly and provide a visual representation of the installation
procedure.
Steps
1. Connect the fan cables to the connectors on the system board.
2. Align the tabs on the fan assembly with the slots on the chassis.
3. Insert the fan assembly at an angle into the slot in the chassis.
4. Install the two (6-32) screws to secure the fan assembly to the chassis.
Next steps
1. Install the
air
shroud.
2. Install the
left-side
cover.
3. Follow the procedure in
assembly.
After working inside your
After working inside your
computer.
computer.
Removing and installing components
69
Advertisement
Table of Contents
