Installing The Front-Nvme Module - Dell Precision 7960 Tower Service Manual

3. Remove the two screws (6-32) that secure the front-NVMe module to the flex1.
4. Lift and remove the front-NVMe module away from the computer.
NOTE: Follow the same procedure to remove the front-NVMe module from the flex0.

Installing the front-NVMe module

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front-NVMe module and provide a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the front-NVMe module with the screw holes on the flex1.
2. Place the front-NVMe module into the slot in the flex1.
Removing and installing components 95