Fiat CONNECT Nav+ Manual page 107

IMPORTANT When selecting
"Name", remember that it is not pos-
sible to add a name already present in
the Telephone (TEL) function directo-
ry.
To enter the characters simply select
them one by one by rotating the en-
coder 14-fig. 1 and then press "EN-
TER" to confirm 15-fig. 1.
After completing the name, select
"OK".
The "Voice recognition" key allows
to associate a voice sample to a desti-
nation stored in the directory. Sym-
bol " " at the left of the key shows if
a sample has already been associated.
Selecting and confirming "Voice
recognition" will display the screen in
fig. 112:
"New voice command": allows
recording of a new voice sample. User
is invited to pronounce twice the name
to be recorded.
"Delete voice command": allows
deletion of a previously recorded voice
sample. If there is no sample, this key
is disabled.
106
"Listen to voice command": repro-
duces a previously recorded voice
sample. If there is no recorded sample,
this key is disabled.
To select the required function, ro-
tate the encoder 14-fig. 1 and press
"ENTER" to confirm 15-fig. 1.
– Service Info (available only by se-
lection from "Atlas"): shows informa-
tion about a "service" selected on the
map fig. 116.
– Locate (available only by selection
from "Atlas"): shows the car position
on the map. All keys are disabled and
an arrow identifies the car position.
Car orientation (arrow direction) can
be modified by rotating the encoder
14-fig. 1 and pressing "ENTER" 15-
fig. 1 to confirm.
fig. 116
RDS-TMC (available only by selection
from "Atlas"): shows information
about the "RDS-TMC" icon selected
on the map fig. 117.
– Home 1 and Home 2: store the
selected point in the relevant memo-
ries.
If a point has already been previous-
ly stored as "Home 1" or "Home 2",
a warning box asks the user for con-
firmation about substitution.
Pressing H1 or H2 17-fig. 1 and then
"ENTER" 15-fig. 1 to confirm, will
start route calculation to the destina-
tion stored in Home 1 or Home 2.
F0C4080g
fig. 117
F0C4081g