Transport And Storage; Installation; Maintenance - Beko QWIK-PURE 15 Installation And Operation Manual

Installation and operation manual

2.5.5 Transport and storage

Inappropriate transport or storage may result in personal injury or damage to property.
In order to ensure safety during the transport and storage of the product and accessories, observe the
following:
• Handle the packaging, the product and accessories carefully.
• Transport and handle the packaged product and accessories according to the markings on the packaging
(note lifting gear attachment points, the centre of gravity and alignment e.g. keep vertical, do not throw
etc.).
• Only use proper means of transport and lifting equipment that is in proper working order.
• Always adhere to the permissible storage parameters.
• Store the product and accessories only outside of areas exposed to direct sunlight, heat sources and
splash water.
• Empty the assembled product before transporting it.

2.5.6 Installation

The improper assembly or electrical installation of the product and accessories may result in personal injury
and damage to property and impair operation.
For safe assembly and electrical installation, observe the following:
• Assemble the product and all the parts, accessories and materials used free of mechanical stress.
• Check all plug-type connections for a correct fit.
• Avoid stumbling risks by routing cables and hoses accordingly.
• Avoid mechanical strain on the cables.
• Fix and fasten hoses in such a way that they cannot flap around.
• Install the inlet and drain lines for condensate and compressed air as fixed pipes.

2.5.7 Maintenance

Improperly carrying out maintenance and repair work may result in serious injury or death.
For safe maintenance and repairs, observe the following:
• Before starting work, depressurise the pressurised product and accessories and secure them against
unintentional pressurisation.
• Before starting work, cut off the condensate feed to the product and divert the incoming condensate into
a separate container.
• Before starting work, disconnect the product and accessories and secure them against being switched
back on again unintentionally.
• Only use materials approved for the respective application.
• Use only suitable tools that are in proper working order.
• Only use cleaned pipes and hoses that are free of dirt and corrosion.
• Never use abrasive or aggressive cleaning agents or solvents which could damage the outer coating
(e.g. markings, type plate, corrosion protection, etc.).
• Never clean the device with hard or pointed implements.
• Use only the specified materials and media for cleaning.
• Observe statutory, local and in-house hygiene regulations.
QWIK-PURE
®
13 | 124