Assembly and Installation
Step 2: Fixing the Assembled Take-up Unit to the Printer Stand
Procedure
1.
Make sure the printer stand screws are not loose.
If they are loose, tighten them once again.
2.
Place the take-up unit on the stand.
• When using the VG-640/540, SG-540/300, LEC2-300, LEC2-640/330, MG-640/300, UG-641
• When using the VF2-640, VG2-640/540, SG2-640/540/300
a. Insert a bolt with washer (large) from the bottom into the hole on the right stand leg.
There are two holes in the stand leg, but only insert the bolt in the hole on the stand post
side.
b. Place the take-up unit on the stand.
12
Assembly and Installation