Table of Contents
Advertisement
1-2 Installation and Transport
Installing the Heater Unit on the Printer
The heater unit is to be installed on the printer by an authorized service engineer.
Never attempt to install the heater unit on the printer by yourself.
About the Power Supply
Be sure to use an electrical outlet for the power supply. Also, do not connect multiple electrical loads on a single
electrical outlet.
Low or unstable voltage may result in inadequate heater performance. If the temperature of the heater fails to rise
adequately even when used correctly, check the voltage of the power supply.
When Moving the Printer
The printer that the heater unit has been installed on cannot be repacked. When repacking the printer, please contact
your authorized Roland DG Corp. dealer or service center.
Chapter 1: Installation
11
Advertisement
Table of Contents
