Selecting The Take-Up Method - Roland TU4-64 User Manual

Selecting the Take-up Method

Installing this machine will cause the printer menu list, etc. to change as follows.
It is possible to select the take-up method ("TU", "TU2", or "TU3") on the "SETUP SHEET" screen.
SETUP SHEET
TU2
Select the take-up method to match the output method.
Take-up method
"TU"
*1
"TU2"
*2
"TU3"
*1 This is not displayed if you are using the VF2-640.
*2 This is only displayed if you are using the LEC2-330, MG-300, or TB-30.
4
Introduction
Output method
Printing only
* However, the case in which the media is
pulled back after printing in order to print
on the media again is excluded.
Cutting only, printing and cutting, crop-
ping and cutting
* However, the case in which the media is
pulled back after printing in order to print
on the media again is included.
Printing only
Description
Take-up is performed at the same time as output. The
work can be completed in less time than is required with
the "TU2" setting. However, this setting causes an error to
occur during output performed with cutting operations,
so this setting cannot be used in this situation.
* When pulling back the media after printing in order to
print on the media again, select the "TU2" setting.
No take-up is performed until the output of the piece of
data is finished. When the output is finished, the length
of media that was output is pulled back and is then taken
up. The work time is longer than that for the "TU" set-
ting, but this setting can be used to perform take-up
even for output performed with cutting operations.
Use this method when using media (such as soft packag-
ing) that is not transported by pulling it back. The cutting
operation and media cut-off are not possible.