c. Note the following points and set the fixing location for the take-up unit.
• Align the bolt with washer (large) inserted in step (1) with the hole in the right slider
stay.
MEMO
If it is difficult to align the bolt with washer (large) with the hole in the right slider stay, adjust
the right slider stay (A) and the stand leg to positions where their inside faces are pointed at
each other. This brings the hole in the right slider stay (B) close to the position of the bolt with
washer (large) and thereby makes it easy to align these parts.
• Place the left and right slider stays approximately 10 mm (0.39 in.) (C) away from the
stand legs.
Assembly and Installation
Assembly and Installation
13