Length Setting When "Tu2" Is Selected - Roland TU4-64 User Manual

Length Setting When "TU2" Is Selected

* If you are using the VF2-640, "TU2" is not displayed.
When "TU2" is selected in the printer menu list, no take-up is performed until the output of the piece of
data is finished. Therefore, if the length to be output at one time is large, the media may touch the work
floor and become soiled. To avoid soiling the media by touching the floor, output in approximately 300 mm
(11.81 in.) increments.
P. 4Selecting the Take-up Method
Use the software RIP function to output limiting the length.
This section describes "how to output by limiting the length" using VersaWorks. For information on the de-
tailed usage of VersaWorks, refer to the VersaWorks user's manual.
Procedure
1.
Open the [Queue Properties] window (or the [Job Settings] window).
Select the input folder.
2.
Click .
3.
Select [CustomCUT] for [Size] under [Media Settings].
4.
Set [H].
[Queue Properties] Window
MEMO
The setting item and the method in the [Job Settings] window are the same as this procedure.
24
Operation