Table of Contents
Advertisement
The printing position of small
label is incorrect
The left side printout position is
incorrect
Missing printing on the left or
right side of label
RTC time is incorrect when
reboot the printer
Power and Error LEDs are
blinking fast
Wrinkle problem
Gray line on the blank label
Irregular printing
* Media sensor sensitivity is not set
properly.
* Label size is incorrect.
* The parameter Shift Y in the LCD
menu is incorrect.
* The vertical offset setting in the
driver is incorrect.
* Wrong label size setup.
* The parameter Shift X in LCD
menu is incorrect.
* Wrong label size setup.
* The battery has run down.
* Power switch OFF and ON too
fast.
* Print head pressure is incorrect.
* Ribbon installation is incorrect.
* Media installation is incorrect.
* Print density is incorrect.
* Media feeding is incorrect.
* The print head is dirty.
* The platen roller is dirty.
* The printer is in Hex Dump mode.
* The RS-232 setting is incorrect.
74
* Calibrate the sensor sensitivity
again.
* Set the correct label size and gap
size.
* Press [MENU] [SELECT]
x3[DOWN]x6 [SELECT] to
fine tune the parameter of Shift Y.
(Option)
* If using the software BarTender,
please set the vertical offset in the
driver.
* Set the correct label size.
* Press [MENU] [SELECT] x 3
[DOWN] x 5 [SELECT] to fine
tune the parameter of Shift X.
(Option)
* Set the correct label size.
* Check if there is a battery on the
main board.
* Turn off the printer and wait all
LEDs are dark, and turn on the
printer again.
* Please refer to the next chapter.
* Please set the suitable density to
have good print quality.
* Make sure the label guide touch
the edge of the media guide.
* Clean the print head.
* Clean the platen roller.
* Turn off and on the printer to skip
the dump mode.
* Re-set the Rs-232 setting.
Advertisement
Table of Contents
