AGFA CG Triumvirate TT042-50 Series User Manual page 43

3.1.1-2.1 Darkness:
Print Setup
> Darkness
Print Speed
Tear off
Use this option to setup printing darkness. The available setting is from 0 to 30, and the
step is 1. Printer default density is 16.You may need to adjust your density based on
selected media.
Press
key to enable the setting. Press
to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.2 Print Speed:
Print Setup
Darkness
> Print Speed
Tear Off
Use this option to setup print speed. The each increment/decrement is 1 ips.
Press
speed. Press
setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.3 Tear Off:
Print Setup
Darkness
Print Speed
> Tear Off
This option is used to fine tune media stop location. Press the
the cursor from left digit to right digit, and press the
to "-" or "0" to "9". Press the
1/17
and to increase/decrease the printing darkness. Press
2/17
key to raise the print speed, and press
key to set it into printer. Press
3/17
Dankness
16
key to cancel the setting and return
Print Speed
6
Tear Off
+000
button to set the value into printer. Press
36
key to decrease print
key to cancel the
button to move
button to set the value from "+"