8. Use the DiagTool to set the media sensor type and calibrate the selected sensor. (Please refer to
section 4)
Note:
Please calibrate the gap/black mark sensor when changing media.
The sensor location is marked by a triangle mark
The media sensor position is moveable. Please make sure the gap or black mark is at
the location where media gap/black mark will pass through for sensing.
6. Adjust the label guide to fit the width of
the label. Make sure the media sensor
triangle indicator is on the paper feed path
that can sense the gap or black or notch
for label registration.
Media sensor indicator
Label guide
7. Close the print head mechanism. Make
sure the latches are engaged securely.
▽
at the sensor housing.
19