Siemens SIMATIC ET 200S M151-3 PN Manual page 10

Properties
1.1 IM 151-3 PN HIGH FEATURE interface module
Requirements
The following requirements apply to a configuration with the
IM 151-3 PN HIGH FEATURE(6ES7151-3BA23-0AB0) interface module:
● You can only use the IM 151-3 PN HIGH FEATURE in operation with the IRT option "high
● Topology configuration when you configure IRT with the option "high performance".
Reset to factory settings
NOTICE
The stations of a bus segment can fail during the reset to factory settings.
SNMP parameters in non-volatile memory are reset to factory settings (as of
SP 3) in the HW Config dialog "Target system > Ethernet > Edit Ethernet nodes", "Reset"
button at "Reset to factory settings".
The following data is not deleted during the reset:
● The MAC address
● The I&M0 data
Note
Deleting the device name
The device name is deleted by the "Reset to factory settings" function.
Note
Substitute value behavior at a reset to factory setting
At a "Reset to factory setting" the modules in the station take on the configured substitute
value behavior or the non-configured state.
Compatibility with the predecessor module
The interface module IM151-3 PN HIGH FEATURE(6ES7151-3BA23-0AB0) is compatible
with interface module IM151-3 PN HIGH FEATURE (6ES7151-3BA20-0AB0 and
6ES7151-3BA22-0AB0).
The new interface module directly replaces the predecessor module in an existing system
without the need for reconfiguration.
An IM151-3BA23 that has been in operation and will now be used as spare part has to be
reset to the state "reset to factory settings."
A firmware update of the predecessor module IM151-3BA22 is not supported.
Configuring
You configure the interface module IM151-3 PN HIGH FEATURE with
10
performance" with STEP 7 as of V5.4 SP4.
Interface module IM151-3 PN HIGH FEATURE (6ES7151-3BA23-0AB0)
STEP 7
V5.3
STEP 7
V5.4 SP 4.
Manual, 08/2010, A5E01584258-04