5
Apply heat to the contraction tube to contract it.
Method 1
Contraction tube
6
Wrap it with the insulation tape twice or more and
position your contraction tube in the middle of the
insulation tape.
Method 1
Insulation tape
40 mm
7
After tube contraction work is completed, wrap it with the
insulation tape to finish.
Three or more layers of insulation are required.
Method 1
IInsulation tape
CAUTION
•
Make sure that the connection parts are not exposed
to outside.
•
Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
•
In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
–
Incomplete wire connections can cause electric
shock or a fire.
Method 2
Contraction tube
Method 2
Insulation tape
35 mm
Method 2
IInsulation tape
Step 15 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses
and options
AR-KH**U remote control (for 360 cassette only)
Entering the mode
for setting the
options
Temperature
button
Timer button
NOTE
•
The remote control display may vary depending on the
model.
1
Enter the mode for setting the options:
a
Remove the batteries from the remote control.
b
While holding down the
(Timer) buttons simultaneously, insert the batteries
into the remote control.
c
Make sure that you are entered to the mode for
setting the options:
Setting the option
values
Mode button
Wheel
(Temp) and
English
23