Table of Contents
Advertisement
Installation Procedure
CAUTION
•
Make sure that the connection parts are not exposed
to outside.
•
Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
•
In case of extending the electric wire, please DO NOT use
a round-shaped Pressing socket.
–
Incomplete wire connections can cause electric shock
or a fire.
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses and
options
Remote controls
Entering the
mode for
setting the
options
High Temp button
Low Temp button
18
English
NOTE
•
The remote control display and buttons may vary
depending on the model.
1
Enter the mode for setting the options:
a
b
c
2
Set the option values.
•
The total number of available options are 24: SEG1 to
SEG24.
•
Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
•
Set a 2-digit value for each option pair in the following
SEG1
Setting
0
the option
SEG7
values
1
SEG13
Mode button
2
High Fan button
SEG19
Low Fan button
3
Remove the batteries from the remote control, and
then insert them again.
While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
Make sure that you are entered to the mode for
setting the options:
WARNING
SEG2
SEG3
SEG4
X
X
X
SEG8
SEG9
SEG10
X
X
X
SEG14
SEG15
SEG16
X
X
X
SEG20
SEG21
SEG22
X
X
X
On (SEG1 to SEG12)
(High Temp) and
SEG5
SEG6
X
X
SEG11
SEG12
X
X
SEG17
SEG18
X
X
SEG23
SEG24
X
X
Off (SEG13 to SEG24)
Advertisement
Table of Contents
