Table of Contents
Advertisement
5 Wrap it with the insulation tape twice or more and
position your contraction tube in the middle of the
insulation tape.
Method 1
Insulation tape
40 mm
6 Apply heat to the contraction tube to contract it.
Method 1
Contraction tube
7 After tube contraction work is completed, wrap it with
the insulation tape to finish.
Three or more layers of insulation are required.
Method 1
IInsulation tape
CAUTION
• Make sure that the connection parts are not exposed
to outside.
• Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
• In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
DB68-09343A-00_IBIM_PAC 미라지 이집트파키스탄_IQ_EN.indd 43
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
Method 2
the installation options in a batch: set both of them
Insulation tape
respectively.
Common steps for setting the addresses and
options
35 mm
Method 2
Contraction tube
Method 2
IInsulation tape
• The remote control display and buttons may vary
1 Enter the mode for setting the options:
Entering the
mode for setting
the options
High Temp button
Low Temp button
NOTE
depending on the model.
a Remove the batteries from the remote control, and
then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
Setting the
option values
Mode button
High Fan button
Low Fan button
(High Temp) and
43
English
2020-07-28 오전 11:08:52
Advertisement
Table of Contents
Troubleshooting
