Step 14 Setting The Indoor Unit Addresses And The Installation Options - Samsung AC BNJDCH Series Installation Manual

Step 14 Setting the indoor unit addresses
and the installation options
• Set the indoor unit address and installation option with a
wireless remote controller. Options and address can also be
modified using wired controllers or service software. You
cannot set both the indoor unit addresses and the installation
options at the same time.
• Please use the proper wireless remote controller which can
set 24 digit option code.
• Please refer to the wired remote controller installation
manual for setting with the wired remote controller.
Common steps for setting the addresses and options
Entering mode for
setting option
High Temp Button
Low Temp Button
NOTE
• The remote control display and buttons may vary depending
on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control, and then
insert them again.
b While holding down the
Temp) buttons simultaneously, insert the batteries into
the remote control.
c Make sure that you are entered to the mode for setting
the options:
Option setting
mode
Mode change
High Fan Button
Low Fan Button
(High Temp) and (Low
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options
used by the previous remote control models, the modes to
set values for these options are skipped automatically.
• Set a 2-digit value for each option pair in the following order:
SEG2 and SEG3 SEG4 and SEG5
SEG9 and SEG10 SEG11 and SEG12
SEG16 and SEG17 SEG18 and SEG20
SEG23 and SEG24
SEG1 SEG2 SEG3
0 X X
SEG7 SEG8 SEG9
1 X X
SEG13 SEG14 SEG15
2 X X
SEG19 SEG20 SEG21
3 X X
On (SEG1 to SEG12)
SEG6 and SEG8
SEG14 and SEG15
SEG21 and SEG22
SEG4 SEG5 SEG6
X X X
SEG10 SEG11 SEG12
X X X
SEG16 SEG17 SEG18
X X X
SEG22 SEG23 SEG24
X X X
Off (SEG13 to SEG24)
English
19