Daily Inspection Before Starting; Pre-Operation Check - Bad Boy 1025H Operator's Manual

5
2
BAD BOY TRACTOR
-
DAILY INSPECTION BEFORE
STARTING
1. Check the engine oil level.
After wiping out the dipstick, insert
it fully and then withdraw it. Oil
should be between the two marks
on dipstick.
Do not operate the engine if oil
level is below minimum mark. If
below, add the corresponding
grade oil according to the season
through the filler.
2. Feed grease to all greasing points
indicated below every 10 hours
when working in damp and muddy
conditions.
Front axle pin

Steering shaft and Cylinder end

Tie rod both ends

Front axle supporter

3. After cleaning the machine with
highly pressurized water, lubricate
the indicated points with grease
below if necessary.
Bonnet latch

Seat sliding rail

1025H.indb 2 1025H.indb 2

PRE-OPERATION CHECK

DANGER
•
Do not provide illumination
with a lit cigarette or a lighter
when fueling.
•
Never fill the fuel tank while
the engine is running or hot.
•
After filling the fuel tank, close
the fuel filler cap complete-
ly and wipe off the excess fuel
thoroughly.
•
If the fuel hoses are damaged,
fuel will leak. Make sure that
you check for any leakage.
WARNING
•
Perform the maintenance on a
flat and safe location that will
keep the tractor in place and
will not cause a risk to peo-
ple passing by. Before carry-
ing out the maintenance, place
blocks at the front tires to pre-
vent movement.
[Otherwise]
An unexpected accident may oc-
cur, such as overturning of the
tractor.
•
When going under the imple-
ment, fully close the slow/stop
valve.
[Otherwise]
There is a risk of injury due to
implement falling.
2021-07-06 오전 11:07:44 2021-07-06 오전 11:07:44