Anti Freeze; Maintenance - Bad Boy 1025H Operator's Manual

1. Open to drain cock.
2. Open the radiator at the same time.
3. To give a thorough clean, run a hose
into the radiator and flush it out.
4. Close the tap and refill the radiator with
a coolant mixture of water and corro-
sion inhibitor or anti freeze.
(5) Start the engine and allow it to run for
approx 5 minutes, check the water
level again and top off if required.
CAUTION
Do not remove the radiator cap

on a hot engine.
Allow the engine to cool down

and then turn the cap slowly to
ensure, that
there is no excessive pressure

in the radiator.
1025H.indb 11 1025H.indb 11
CAUTION
Serious burns can result from

the contents of pressurized, hot
radiators.
Allow the engine to cool down

completely before opening the
radiator.

MAINTENANCE

ANTI FREEZE

Frozen cooling water can damage the en-
gine.
Before replacing the anti freeze solution
flush the radiator.
Mix the anti freeze solution in accordance
with the instructions applicable to the
brand of anti freeze and the local climate.
Replace the solution in the radiator.
In the case of the loss of solution due to
evaporation or overflow, replace with the
original mixture ratio.
IMPORTANT
Water or air under high pressure

can distort the cooling fins on
the radiator and reduce their ef-
ficiency.
6
11
-
6
2021-07-06 오전 11:07:51 2021-07-06 오전 11:07:51