Changing Oil In The Front Axle - Bad Boy 1025H Operator's Manual

CHANGING OIL IN THE FRONT AXLE

(1) Fill/Level Plug
(A) Upper Level (B) Lower Level
1025H.indb 9 1025H.indb 9
(1) Front Axle Drain Plug
1. Drain the oil from the center diff
plug and the drain plug in each
drive.
2. Replace and tighten all drain
plugs.
3. Remove the Fill/Lever plugs from
each final drive to vent air from the
final drives.
MAINTENANCE
4. Remove the dip stick from the filter
hole and fill with front axle oil ca-
pacity to 3.2ℓ (0.85 US gal) and al-
low time for the oil to drain into the
final drives.
5. Check the oil level with the dipstick
and replace the Fill/Lever plugs on
both final drives and tighten
IMPORTANT
Some operators have found that

when they fill up with the correct
amount of oil ,the level on the
dipstick is too high due to the
fact that it takes a while for the
oil to run into the final drives.
Opening the Vent plugs helps to

speed this up.
2021-07-06 오전 11:07:51 2021-07-06 오전 11:07:51
6
9
-
6