Toyota Super SP200 Series Instruction Manual page 56

Attaching the Bobbin Case
Position the bobbin case so part
on the bobbin case is below
part on the sewing machine.
Insert the right side of the bobbin
case into the hook so part
bobbin case is to the left of part
on the sewing machine.
Make sure that the bobbin case is fully installed in the hook.
<Correct>
The entire bobbin case fits into the
hook so that the edge of the hook is
visible.
Part on the bobbin case is to the left
of part
Note:
Carefully check the bobbin case since it may be incorrectly installed
even though part
machine, as shown in the above diagram on the right.
56
Make sure that
the bobbin case
moves slightly in
the direction of
the arrow.
on the sewing machine.
of the bobbin case is to the left of part
on the
Edge of hook
<Incorrect>
The right side of the bobbin case
covers the edge of the hook and
the bobbin case is tilted.
With the bobbin case tilted to
the left, insert the left side of
the bobbin case into the hook,
as shown.
Left side of
bobbin case
Right side of
bobbin case
on the