Toyota Super SP200 Series Instruction Manual page 15

WARNING
While the bobbin is being wound, do not touch the thread winding
spindle or the handwheel.
Doing so could cause an injury.
Pull the thread from the thread
spool, and then hold it with one
hand while passing it around the
thread guide with the other hand,
as shown.
Hold in place with
Thread guide
your finger.
Spool pin (
Thread winding spindle
(
Main power switch
(
Foot controller
(
While holding the thread end, begin
pressing on the foot controller with
your foot.
After the thread has been wound
around the bobbin about 10 times,
release the foot controller to stop
winding.
)
)
)
)
Pass the thread end through the
hole in the bobbin as shown.
Place the bobbin on the thread
winding spindle so the groove
aligns with the shaft projection.
Hole
Thread
winding
spindle
Slide the thread winding spindle
in the direction of the arrow until
it snaps into place.
Turn on the machine.
Main power switch
Foot controller
EN
Thread
3
Groove
Bobbin
Shaft
projection
15