WARNING
When using the buttonhole cutter to cut the buttonholes, do not hold
the fabric in front of the cutter.
Doing so could cause an injury to your hand.
Use the buttonhole cutter to cut the
center, making sure not to cut the
stitches.
Note:
Placing a marking pin in the bar-
tack area helps to prevent cutting
the bar-tack with the buttonhole
cutter.
Adjustment of buttonhole balance
Use the buttonhole adjustment
screw to adjust the balance between
the stitches (rear side).
Adjust by turning with the
driver of your own.
Don't turn the screw more than 90°.
Note:
The original position of buttonhole
adjustment screw may vary
according to the model of machine.
If the stitches are loose on the right
side of the buttonhole, turn slightly
in the "-" direction.
40
Buttonhole
screw
If the stitches are loose on the left
side of the buttonhole, turn slightly
in the "+" direction.
cutter
Buttonhole
adjustment
screw