Toyota Super SP200 Series Instruction Manual page 49

Steam iron the side seam areas.
Tip: If the side seam areas are very bulky,
flatten them with a wooden mallet,
etc., so that the seam can be easily
sewn.
Remove the accessory compartment,
and then pull the jeans hem over the
free arm as shown in the illustration.
Sew around the jeans hem, starting
about 2 cm (0.8 inch) in front of the
inside leg seam (refer to the illustration).
Secure the beginning and end of the
stitching with a few reverse stitches.
WARNING
Do not sew reverse stitches over the seam areas.
Doing so could break the needle and cause injuries.
Tip: Use the quilting guide in order to sew parallel with the edge of jeans.
WARNING
Before inserting the quilting guide,use the main power switch to turn
off the sewing machine. Not doing so could cause an injury.
Insert the quilting guide under the spring
plate on the shank. Adjust the quilting
guide to the correct position by moving it
sideways.
Position the quilting guide on the edge of
jeans and sew.
Beginning of
sewing
2 cm (0.8 inch)
Seam area
EN
4
49