Table of Contents
Advertisement
Programming the Options
Viewing Information on Terminal
Options and Parameters
You can use the 8410D, 8411D, and 8434DX display screen to view options and
parameters that have been set at a particular voice terminal.
NOTE:
In order for you to view this information, the set must be on-hook and idle,
and it must equipped with a display .
To view voice terminal options and parameters for a specific set
1. While on-hook at that voice terminal, press
2. Press
3. Enter ''00'' OR ''11'' OR ''##'' according to the type of information you wish
to view.
4. To view more information on terminal options and parameters, repeat
Steps 1 through 3.
80
The light next to
Shift
.
Mute
The light next to
Shift
Press ''00'' to view what Speakerphone, Mute, Handset Expander,
and Ringer Preference options are set.
Press ''11'' to view the Compander, Display Font (Domestic or
International), and DLI settings. Also shown is information about
the Primary and Adjunct levels selected (either ROM if the defaults
are operating or the checksum bytes of the parameter message
that set the levels).
Press ''##'' to check the software version currently installed in the
terminal and whether the terminal is operating in 4-wire or 2-wire
mode.
The information is displayed on the screen for approximately
five seconds and then disappears.
.
Shift
goes on.
goes off.
Advertisement
Table of Contents
