Table of Contents
Advertisement
Installing Your Voice Terminal
Connecting an Analog Adjunct to the 8411
Voice Terminal
Through the Analog Adjunct RJ11C jack on the rear of the set, the 8411 voice
terminal provides connection with Analog Adjuncts such as answering machines,
fax machines, PC or laptop data/fax modem cards, data sets or modems, audio
teleconferencing equipment, and TTY machines commonly used by the hearing
impaired. On System 75, System 85, and DEFINITY G1 and G2 switches and
DEFINITY G3 systems prior to G3V4, Issue 3, the analog equipment shares the
telephone line (or I1-Channel) with the voice terminal. Therefore, while the
telephone is being used, you cannot use the Analog Adjunct at the same time, or
vice versa. Beginning with DEFINITY G3V4, Issue 3, the 8411 and Analog
Adjunct can use separate telephone lines (the I1-Channel and I2-Channel) and
thus the voice terminal and the Analog Adjunct can be used simultaneously.
To connect an Analog Adjunct to the 8411
1. Connect the line cord of the Analog Adjunct to the Analog Adjunct jack on
the rear of the 8411 voice terminal.
NOTE:
At the DEFINITY G3V4, Issue 3, switch, the 8411 voice terminal must be
optioned to use the appropriate DCP I-channel (either the I1-Channel or
the I2-Channel). For administration of the 8411 with DEFINITY G3V4,
Issue 3, and later switches, see ''Administering the 8410 and 8411 Voice
Terminal'' later in this manual.
PassageWay and Analog Adjunct
Status Indications on the 8411
The system manager may choose to administer Button #9 on the 8411 voice
terminal, the next-to-last button in the second column, so that the lights next to
these buttons show the status of the PassageWay connection (the PC can be
connected to the RS-232-D jack on the rear of the 8411). Button #10, the last
button in the second column, can be administered to monitor the status of the
Analog Adjunct (this adjunct equipment can be connected to the Analog Adjunct
jack on the rear of the 8411). See Figure 12 for the location of Buttons #9 and
#10.
30
WARNING:
Do NOT connect the Analog Adjunct to the wall jack. It will cause
equipment damage.
Advertisement
Table of Contents
