Table of Contents
Advertisement
Programming the Options
Selecting Whether the I1-Channel or
the I2-Channel Will Be Used for the
Analog Adjunct (For the 8411 Only)
If the 8411 is connected to a DEFINITY G4, Issue 3 (or later) switch, the Analog
(Tip/Ring) Adjunct and voice terminal can handle calls simultaneously over the
I1-Channel or the I2-Channel. The system manager can administer the voice
terminal to select which of the two channels the Analog (Tip/Ring) Adjunct will
use.
To select which channel (the I1-Channel or the I2-Channel) the Analog (T/R)
Adjunct will use
1. While on-hook, press
2. Press
3. Enter the 2-digit code, ''42'' (''IC'').
4. Press either ''1'' or ''2'' to change the setting:
or
if the voice terminal has a display, press
to save the desired option and then exit programming.
#
76
If the voice terminal saves your selection, the first three
green call appearance lights go on and, if you have a display,
a confirmation message is displayed.
If the voice terminal cannot save this selection, the first three
red call appearance lights go on and, if you have a display, an
error message is displayed. In this case, the selected option
will be in effect until power is removed from the set. If this
happens, try repeating the process. If the option still cannot be
saved, the terminal may be faulty.
.
Shift
The light next to
Shift
.
Mute
The light next to
Shift
The red light next to
Shift
The current setting (either T/R ON I1 CHANNEL or T/R ON I2
CHANNEL) is shown on the display, if there is one.
Press ''1'' to select the I1-Channel for Analog Adjunct transmission
Press ''2'' to select the I2-Channel for Analog Adjunct transmission
After pressing ''1'' or ''2'' or pressing ''#'', the light next to
goes off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three
goes on.
goes off.
flutters.
∗
to change the setting. Press
Shift
Advertisement
Table of Contents
