Table of Contents
Advertisement
Installing Your Voice Terminal
Desktop Installation
The following instructions are for a desktop installation. If you are mounting the
voice terminal on the wall, proceed to the next section, ''Wall Installation.''
1. Turn the voice terminal face down on a flat surface. Then, use the
following figures for installation.
According to the 8400-Series model you are using, refer to these three
figures for the location of the jacks referred to in the following steps.
2. For all voice terminals, snap one end of the line cord into the ''LINE'' jack
and the adjunct cord (if applicable) into the Adjunct jack on the bottom of
the voice terminal. (The Adjunct jack is labeled
the 8411, on which the jack is labeled ''ADJUNCT.'') For more information
on installing adjuncts, refer to the section ''Attaching Adjunct Equipment.''
14
Figure 2 shows the bottom of the 8403 voice terminal. You can
use this diagram for installing the 8403 or the 8410. However, note
that the location of the routing channels on the 8410 differs slightly
from the 8403. Also, the Handset jack on the 8410 is in a different
location.
Figure 3 shows the bottom of the 8411 voice terminal.
NOTE:
The rear of the 8411 set includes two jacks: the Analog
Adjunct jack, for connecting answering machines, fax
machines, PC or laptop data/fax modem cards, data sets or
modems, audio teleconferencing equipment, and TTY
machines commonly used by hearing impaired, and the
RS-232-D Jack for connecting the voice terminal to a COM
port on an IBM®- compatible personal computer on which
you can load PassageWay Solution software. For
instructions on connecting hardware to these jacks, see
''Connecting a Personal Computer and an Analog Adjunct to
the 8411 Voice Terminal'' which appears later in this manual.
Figure 4 shows the bottom of the 8434DX voice terminal. This
diagram can be used for installing the 8434DX.
NOTE:
If you are installing an 8410D voice terminal, refer to ''Adjusting the
8410D Voice Terminal Desktop Stand'' for choosing whether the
desktop stand should be in the high or low position. On the 8411,
decide whether you want the kickstand in the up or the down
position.
Important:
If you are routing the cords on the 8410D voice terminal and the
desktop stand is in the high position, you may need to place the
cords through the long, rectangular opening that surrounds the jacks
on all sets except
Advertisement
Table of Contents
