Table of Contents
Advertisement
Programming the Options
Depending on the needs of the telecommunications administrator and individual
users at an installation site, a service technician may be called upon to change
the following settings for the 8400-Series voice terminal:
Enable or disable the speakerphone or listen-only speaker (the default for
the 8403 is the 1-way listen-only speaker enabled; the default for the
8410, 8411, and 8434DX voice terminals is full 2-way speakerphone
enabled)
Enable or disable the Mute function (the default is Mute enabled)
Select a ringing preference for an incoming call when you are busy on
another call (the default is Continuous Ringing)
Enable or disable status lights on the 8411 for the PassageWay interface
(the default setting is Status Lights disabled)
Enable or disable status lights on the 8411 for the Analog (Tip/Ring)
Adjunct connected to the Analog Adjunct jack (the default setting is Status
Lights disabled)
Select whether the I-1 Channel or the I-2 Channel on the 8411 voice
terminal will be used for the Analog Adjunct transmission
Set the audio volume control levels for the speakerphone and handset on
the 8411 voice terminal (the default is retention of the current volume
setting for both speakerphone and handset until the user changes the
settings).
Set the display for one or two lines (this option is available only on the
8434DX voice terminal; the default setting is a 2-line display)
69
Advertisement
Table of Contents
