Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual page 122

parameter is relevant only in case the tone is not Amplitude Modulated.
•
be zero (0) for a single tone. This parameter is relevant only in case the tone is not
Amplitude Modulated.
•
the first cadence ON-OFF cycle, for cadence tone. When a tone is configured to be
continuous, this parameter defines the tone On event detection time. When a tone is
configured to be burst tone, it defines the tone's duration.
•
the first cadence ON-OFF cycle, for cadence tone. In case of burst tone, this
parameter defines the off time required after burst tone ended until the tone detection
is reported. For a continuous tone, this parameter is ignored.
•
for the second cadence ON-OFF cycle. This may be omitted if there is no second
cadence.
•
for the second cadence ON-OFF cycle. This may be omitted if there is no second
cadence.
•
the third cadence ON-OFF cycle. This may be omitted if there is no third cadence.
•
the third cadence ON-OFF cycle. This may be omitted if there is no third cadence.
•
the forth cadence ON-OFF cycle. This may be omitted if there is no forth cadence.
•
the forth cadence ON-OFF cycle. This may be omitted if there is no forth cadence.
•
Amplitude Modulated.
•
Amplitude Modulated (valid range from 1 Hz to 128 Hz).
•
Modulated.
•
50. Recommended values: 10 to 25.
•
generated tone.
Installation, Operation, Maintenance Manual
High Freq Level [-dBm] - Generation level. 0 to -31 dBm. The value should
First Signal On Time [10 msec] - "Signal On" period (in 10 msec units) for
First Signal Off Time [10 msec] - "Signal Off" period (in 10 msec units) for
Second Signal On Time [10 msec] - "Signal On" period (in 10 msec units)
Second Signal Off Time [10 msec] - "Signal Off" period (in 10 msec units)
Third Signal On Time [10 msec] - "Signal On" period (in 10 msec units) for
Third Signal Off Time [10 msec] - "Signal Off" period (in 10 msec units) for
Forth Signal On Time [10 msec] - "Signal On" period (in 10 msec units) for
Forth Signal Off Time [10 msec] - "Signal Off" period (in 10 msec units) for
Carrier Freq [Hz] – the Carrier signal frequency in case the tone is
Modulation Freq [Hz] – The Modulated signal frequency in case the tone is
Signal Level [-dBm] – the tone level in case the tone is Amplitude
AM Factor [steps of 0.02] – Amplitude modulation factor. Valid values: 1 to
Default Duration [msec] - The default duration (in 1 msec units) of the
122
Media Gateway 3500
Document # LTRT-90704