Performing The Online Software Upgrade - Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual

To remove a previously configured Jumpstart Server, take these 2
steps:
1. Connect
/jumpstart/Solaris_9_904_v1.0/Solaris_9/Tools/ and press Enter.
EMS-Server8:/ [root] => cd /jumpstart/Solaris_9_904_v1.0/Solaris_9/
Tools/
2. Unconfigure the SC boards by typing ./rm_install_client followed by the SC
hostname. Press Enter. Do the same for the second SC board.
EMS-Server8:/ [root] => ./rm_install_client [SC1_hostname]
EMS-Server8:/ [root] => ./rm_install_client [SC2_hostname]
Note that path to the ./rm_install_client script may differ, depending on the Solaris OS
image version. If you are not sure how to unconfigure Jumpstart server, contact Nortel
support.
15.4

Performing the Online Software Upgrade

This section describes an Online Software Upgrade in a typical Media Gateway
configuration when 2 SC boards are available. If your system has only 1 SC board, refer to
'Online Software Upgrade Wizard on a Simplex Configuration' on page 185.
Before starting Online Software Upgrade verify in the EMS that:
Both SC boards are green (AdministrativeState=UNLOCKED,
OperationalState=ENABLED);
Both Ethernet Switch boards are green (AdministrativeState=UNLOCKED,
OperationalState=ENABLED);
All unlocked Media Gateway boards are green (AdministrativeState=UNLOCKED,
OperationalState=ENABLED); if you have a malfunctioning Media Gateway board –
LOCK it.
Installation, Operation, Maintenance Manual
to the Jumpstart
168
server's Telnet or
Media Gateway 3500
RS232 console. Type
Document # LTRT-90704